AMC 20 Suggestions

[CJohn7]

Time to dump those 2piece shafts. I'm thinking of getting the Moser shafts, any comments there? And any other ideas on upgrading this axle.

 

[re-run]

I put superiors in my old cj. they worked great for me.

 

[CJKarl]

I'm going through the same thing now. Thinking of doing a locker too.

 

[Used-TJ]

Try this thread from a month ago

http://northeastjeep.org/forum/viewtopic.php?t=2142&highlight=amc+20

 

[pyagid]

Does the 20 require a truss? :roll:

depends if it is for the mall, or the trail

 

[pyagid]

I ran mine with 1 piece axles, untrussed for about 4 years on 33's and never had a problem. my drivetrain was a 360/t-18. Bigger than 33's i would think about trussing it, or heavy on the skinny pedal

-Paul

 

[CJohn7]

Ron sent you a pm.

 

[Used-TJ]

From what I have heard from the guys in NE4W who still run the 20's, if you upgrade to the 1 piece axles they are comparable to a D44.
just make sure they are true forged 1 piece axles and NOT 2 piece axles that have been welded.

 

[CJKarl]

From what I have heard from the guys in NE4W who still run the 20's, if you upgrade to the 1 piece axles they are comparable to a D44.
just make sure they are true forged 1 piece axles and NOT 2 piece axles that have been welded.

...I also read that rolled splines are stronger than cut splines. Rolled are put in before heat treating...cut, after.

 

[CJohn7]

I am setting it up for the mall, but EXTREME mall riding. I'm talkin' two wheels up on a 6 inch curb. Too risky to pull in front of with the new mini van in fear of a steel bumper goring the sliding door.

 

[SVENG52]

... but i never wheel or abuse my jeep... s

Jeep Blasphemy

Bullet

:lol: :lol: :lol: