Ford 8.8 - C-Clip Eliminator Kit
- Thread starter joe98tj
- Start date
joe98tj
Moderator
One thing to note was before I left for the rubicon I did find that one of the nuts came off one of the bolts that holds the axle shaft in.
Theres always the chance i forgot to tighten that one down but I used loctite on all the nuts so its probably good to just give all the bolts a spin check a while after installation. You don't have to remove the tire to check if the nuts are still tight with the bolt heads being exposed on the back side.
Theres always the chance i forgot to tighten that one down but I used loctite on all the nuts so its probably good to just give all the bolts a spin check a while after installation. You don't have to remove the tire to check if the nuts are still tight with the bolt heads being exposed on the back side.
