RedJeepster1
Active member
Spokey Dokeys said:
You cut it off and weld a new one on.
Sent from my iPhone using Tapatalk Pro
Project Silver XJ
- Thread starter RedJeepster1
- Start date
You cut it off and weld a new one on.
Sent from my iPhone using Tapatalk Pro
MasterDrazhar
New member
Hey, I know two guys who can get that driveshaft separated for you...
RedJeepster1
Active member
A new slip joint rebalance and paint the shaft again is going to cost almost as much as a new driveshaft.
And yes I know Tom can cut this and machine it and get it back together, but with the amount of highway driving I do, I want a balanced driveshaft. And at the rates my local driveshaft shop charges, it’s better for me to just order a shaft from Adam’s and Tom Woods.
Sent from my iPhone using Tapatalk Pro
And yes I know Tom can cut this and machine it and get it back together, but with the amount of highway driving I do, I want a balanced driveshaft. And at the rates my local driveshaft shop charges, it’s better for me to just order a shaft from Adam’s and Tom Woods.
Sent from my iPhone using Tapatalk Pro
50willysM38
Active member
Would that be considered undocking?MasterDrazhar said:
TJlongworth
Moderator
Lol I don't think I've told you that story ... But those guys got it apart, but the rest did not go so well
RedJeepster1
Active member
Installed hood vents on the XJ on Saturday morning. Big thanks to Alan for sending me these a year or two ago. After looking at the forecast for Sunday and seeing over 80 degrees and humid, I just figured it was time.
When we were out in the woods yesterday, there was definitely some heat rising out of them. Later this summer when it gets good and hot I’ll know if they eliminated the heat soak issue that all of the 00-01 XJ’s have.
Sent from my iPhone using Tapatalk Pro
When we were out in the woods yesterday, there was definitely some heat rising out of them. Later this summer when it gets good and hot I’ll know if they eliminated the heat soak issue that all of the 00-01 XJ’s have.
Sent from my iPhone using Tapatalk Pro
YJScrounge
Moderator
Should help with cooling.
I have YJ hood I want to cut old school lovers into. I can't seem to find any old guys out there that did them back in the day.
I have YJ hood I want to cut old school lovers into. I can't seem to find any old guys out there that did them back in the day.
RedJeepster1
Active member
YJScrounge said:
You could go new school old school and borrow my dimple dies. The look is a little different, the result is mostly the same.
Sent from my iPhone using Tapatalk Pro
YJScrounge
Moderator
RedJeepster1 said:YJScrounge said:
Hmmmmmmmm.............
You could go new school old school and borrow my dimple dies. The look is a little different, the result is mostly the same.
Sent from my iPhone using Tapatalk Pro
