track bar questions???

[tj97jeepster]

I just got my new Rear RE track bar. As I was going to take the old one off I saw that it had a relocator on there already. Do I use the this with my new RE track bar or do I use the stock locations.

thanks
steve

 

[ab]

i had to take my relocator off to get my adj. track bar on.

 

[NomadJeep]

It depends on the brand bar, and how much lift.

Usually the bracket is still used because it will put the bar back at a higher level so when you hit a bump, it will not have to move as much.  Think of it this way, if the bar is higher, then when you go up and down, it does just that, however if the bar is lower, then as you hit a bump, it will often have to move over to get past the parallel curve.  Thus it will move the axle over until you reach the top side of the curve.  Sounds funny, but the best bet is to just follow the directions, and adjust...

here is one style track bar from RE

PDF:
http://www.rubiconexpress.com/instructions/rubiconexpress/RE1602-RE1603-RE1604B.pdf

 

[tj97jeepster]

thanks guys ill see if this will work...